Allied Telesis AT-S70 - Manual (Page 166)

Chapter 9: SNMPv3
166
Enter View Subtree (OID format/Text Name):
7. Enter the View Subtree value for this View Name.
You can enter either a numeric value in hex format or the equivalent
text name. For example, the OID hex format for TCP/IP is:
1.3.6.1.2.1.6
The text format is for TCP/IP is:
tcp
The following prompt is displayed:
Enter View Type [I-Included, E-Excluded]:
8. Choose one of the following view types:
I-Included
Enter this value to permit the View Name to see the subtree specified
above.
E-Excluded
Enter this value to not permit the View Name to see the subtree
specified above.
9. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
10. From the System Configuration Menu, select Save Configuration
File.
Modifying a Storage Type
To modify the Storage Type parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, shown in Figure 10 on
page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.