Allied Telesis AT-S70 - Manual (Page 198)

Chapter 9: SNMPv3
198
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 Group Table menu, type N to display the Next
Page and P to display the previous page.
4. To delete an SNMPv3 Notify Table entry, select Delete SNMPv3
Table Entry.
The following prompt is displayed:
Enter Notify Name:
5. Enter a Notify Name.
The following prompt is displayed:
Do you want to Delete this table entry? (Yes or No):
6. Enter Y to delete the selected table entry or N to save the entry.
7. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
8. From the System Configuration Menu, select Save Configuration
File.
Modifying an
SNMPv3 Notify
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. Refer to the following procedures:
ˆ “Modifying a Notify Tag” on page 198
ˆ “Modifying a Notify Type” on page 200
ˆ “Modifying a Storage Type” on page 201
Modifying a Notify Tag
To modify the Notify Tag parameter in an SNMPv3 Notify Table entry,
perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.