Allied Telesis AT-S70 - Manual (Page 18)

Chapter 1: Overview
18
Remote Management Session
You can use any management workstation on your network that has the
Telnet application protocol to manage a Converteon™ chassis. This type
of management session is referred as a remote management session
because you do not have to be in the wiring closet where the chassis is
located.
To establish a Telnet management session for any Converteon™ chassis,
the chassis must have a management card and an IP address. Before
performing the Telnet management session, note the followings:
ˆ The 10/100Base-TX port on the management card must be connected
to the network.
ˆ The remote management workstation must reach the chassis through
the subnet of the management card.
Note
For instructions on how to start a Telnet management session, refer
to “Starting a Remote Management Session” on page 26.