Allied Telesis AT-S70 - Manual (Page 184)

Chapter 9: SNMPv3
184
Note
If you have selected SNMPv1 or SNMPv2c, N-NoauthNoPriv is the
only security level you can select.
Enter Storage Type [V-Volatile, N-NonVolatile]:
9. Select one of the following storage types for this table entry:
V-Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 Access Table to the configuration file.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Access Table to the configuration file. Allied Telesis
recommends this storage type.
10. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
11. From the System Configuration Menu, select Save Configuration
File.
Displaying the
SNMPv3 Access
Table Menu
This section describes how to display the Display SNMPv3 Access Table
menu. For information about the SNMPv3 Access Table parameters, see
“Creating an SNMPv3 Access Table Entry” on page 169.
To display the Display SNMPv3 Access Table menu, perform the following
procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Access Table.
The Configure SNMPv3 Access Table menu is displayed, as shown in
Figure 68 on page 170.
4. From the Configure SNMPv3 Access Table menu, select Display
SNMPv3 Table Entry.