Allied Telesis AT-S70 - Manual (Page 186)

Chapter 9: SNMPv3
186
Configuring the SNMPv3 Group Table
This section contains a description of the SNMPv3 Group Table and how
to create, delete, and modify table entries. The SNMPv3 Group Table
allows you to associate a User Name with a Group Name. The User Name
is configured in the Configure SNMPv3 User Table menu while the Group
Name is configured in the Configure SNMPv3 Access Table menu. In
addition, the configuration in the Configure SNMPv3 Access Table menu
defines which MIB views this User can read, write (modify), and send traps
from. For each User Name, you can assign:
ˆ A Security Model (SNMPv1, SNMPv2c, SNMPv3)
ˆ A Group Name
ˆ A Storage Type
There are three functions you can perform with the SNMPv3 Access
Table.
ˆ “Creating an SNMPv3 Group Table Entry,” next
ˆ “Deleting an SNMPv3 Group Table Entry” on page 188
ˆ “Modifying an SNMPv3 Group Table Entry” on page 190
ˆ “Displaying the SNMPv3 Group Table Menu” on page 193
Creating an
SNMPv3 Group
Table Entry
To create an entry in the Group Table, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Group Table.