Allied Telesis AT-S70 - Manual (Page 226)

Chapter 9: SNMPv3
226
The Modify SNMPv3 Target Parameters Table menu is displayed, as
shown in Figure 81.
Figure 81. Modify SNMPv3 Target Parameters Table Menu
5. To change the Security Name parameter, select Set Security Name.
The following prompt is displayed:
Enter Target Parameters Name:
6. Enter a previously configured Target Parameters Name.
Enter a value of up to 32 alphanumeric characters.
The following prompt is displayed:
Enter User (Security) Name:
7. Enter a User Name.
Enter a value that you previously configured with the Configure
SNMPv3 User Table menu. You can enter a value of up to 32
alphanumeric characters.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying the Security Model
For the Security or User Name you have selected, the value of the
Security Model parameter in an SNMPv3 Target Parameter Table entry
must match the value of the Security Model parameter in the SNMPv3
Access Table entry.
Converteon
Configure SNMPv3 Target Parameters Table
Modify SNMPv3 Table Entry
Set Security Name (User Name)
Set Security Model
Set Security Level
Set Message Process Model
Set Storage Type
Return to Configure SNMPv3 Target Parameters Table ...