Allied Telesis AT-S70 - Manual (Page 225)

AT-S70 Management Software User’s Guide
225
Note
You cannot modify an entry in the SNMPv3 Target Parameter Table
that contains a value of “default” in the Target Parameters Name
field.
Modifying the Security Name (User Name)
In the AT-S70 implementation of the SNMPv3 protocol, the Security Name
and the User Name parameters are equivalent. In the SNMPv3 Target
Parameters Table menu, the Security Name and the User Name
parameters are used interchangeably.
When you modify the Security Name parameter, you must use a value that
you configured with the User Name parameter in the Configure SNMPv3
User Table menu. If you do not use a value configured with the User Name
parameter, messages are not sent on behalf of this User Name. Refer to
“Creating an SNMPv3 User Table Entry” on page 146.
To modify the Security Name parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Target Parameters Table.
The Configure SNMPv3 Target Parameters Table menu is displayed,
as shown in Figure 80 on page 220.
4. From the Configure SNMPv3 Target Parameters Table menu, select
Modify SNMPv3 Table Entry.