Allied Telesis AT-S70 - Manual (Page 192)

Chapter 9: SNMPv3
192
This value must match a value configured in the Group Name
parameter in the Configure SNMPv3 Access Table. Refer to “Creating
an SNMPv3 Access Table Entry” on page 169.
9. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
10. From the System Configuration Menu, select Save Configuration
File.
Modifying the Storage Type
To modify the Storage Type in an SNMPv3 Group Table entry, perform the
following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Group Table.
The Configure SNMPv3 Group Table menu is displayed, as shown in
Figure 71 on page 187.
4. From the Configure SNMPv3 Group Table, select Modify SNMPv3
Table Entry.
The Modify SNMPv3 Group Table is displayed, as shown in Figure 72
on page 191.
5. To modify the storage type, select Set Storage Type.
The following prompt is displayed:
Enter User (Security) Name:
6. Enter a User Name.
The User Name must be previously configured in the Configure
SNMPv3 User Table menu. Refer to “Creating an SNMPv3 User Table
Entry” on page 146.