Allied Telesis AT-S70 - Manual (Page 243)

AT-CV5000 Media Converter Chassis Installation Guide
243
8. Type Y for to start the download.
The following prompt is displayed:
Downloading Image through TFTP...........
After the system has downloaded the new image, it reboots and begins
to initialize the software. The system does not forward any network
traffic during the initialization process.
Note
Wait until the software is initialized before you attempt to reestablish
your management session.
Downloading the
AT-S70 Software
Image File Using
Xmodem
To download a new AT-S70 software image onto a chassis from a local
management session using Xmodem, perform the following procedure:
1. Establish a local management session on the chassis where you
intend to download the new management software.
2. From the Main Menu, select Image Download.
The Image Download menu is displayed, as shown in Figure 83 on
page 242.
3. From the Image Download Menu, select CPM Image Download
Through XMODEM.
The following prompt is displayed:
Ready to download application image through XModem.
Warning: During Image Download Management activity is
disabled.
Do XMODEM download now? (Yes or No):
4. Enter Y to start the download process or N to cancel.
The following prompt is displayed:
Ready to download .....
5. Begin the image file transfer of the new management software image.
Note
The transfer protocol must be Xmodem or 1K Xmodem.
The following steps illustrate using the Hilgraeve HyperTerminal
program to download the file.