Allied Telesis AT-S70 - Manual (Page 159)

AT-S70 Management Software User’s Guide
159
Configuring the SNMPv3 View Table
This section contains a description of the SNMPv3 View Table and how to
create, delete, and modify table entries. Creating this table, allows you to
specify a view using the following parameters:
ˆ Subtree OID
ˆ Subtree Mask
ˆ MIB OID Table View
To configure the SNMPv3 View Table, you need to be very familiar with
the OID table. You can be very specific about the view a user can or
cannot access—down to a column or row of the table. AT-S70 supports
the Internet subtree of the OID table.
There are three functions you can perform with the SNMPv3 User Table:
ˆ “Creating an SNMPv3 View Table Entry,” next
ˆ “Deleting an SNMPv3 View Table Entry” on page 162
ˆ “Modifying an SNMPv3 View Table Entry” on page 163
ˆ “Displaying the SNMPv3 View Table Menu” on page 167
Creating an
SNMPv3 View
Table Entry
To create an entry in the SNMPv3 View Table, perform the following
procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
View Table.