Allied Telesis AT-S70 - Manual (Page 223)

AT-S70 Management Software User’s Guide
223
11. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
12. From the System Configuration Menu, select Save Configuration
File.
Deleting an
SNMPv3 Target
Parameters Table
Entry
You may want to delete an entry from the SNMPv3 Target Parameters
Table. When you delete an SNMPv3 Target Parameters Table entry, there
is no way to undelete, or recover, the entry.
To delete an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Target Parameters Table.
The Configure SNMPv3 Target Parameters Table menu is displayed,
as shown in Figure 80 on page 220.
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 Group Table menu, type N to display the Next
Page and P to display the previous page.
4. To delete an SNMPv3 Target Parameters Table entry, select Delete
SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a Target Parameters Name.
The following prompt is displayed:
Do you want to Delete this table entry? (Yes or No):
6. Enter Y to delete the selected table entry or N to save the entry.