Allied Telesis AT-S70 - Manual (Page 191)

AT-S70 Management Software User’s Guide
191
The Modify SNMPv3 Group Table is displayed as shown in Figure 72.
Figure 72. Modify SNMPv3 Group Table Menu
5. To modify the Group Name, select Set Group Name.
The following prompt is displayed:
Enter User (Security) Name:
6. Enter a User Name.
The User Name must be previously configured in the Configure
SNMPv3 User Table menu. Refer to “Creating an SNMPv3 User Table
Entry” on page 146.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
7. Enter the Security Model configured for this User Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols:
1-v1
Select this value if this User Name is configured with the SNMPv1
protocol.
2-v2c
Select this value to associate the User Name with the SNMPv2c
protocol.
3-v3
Select this value to associate the User Name with the SNMPv3
protocol.
The following prompt is displayed:
Enter Group Name:
8. Enter the new Group Name.
Converteon
Configure SNMPv3 Group Table
Modify SNMPv3 Table Entry
Set Group Name
Set Storage Type
Return to Configure SNMPv3 Group Table ...