Allied Telesis AT-S70 - Manual (Page 178)

Chapter 9: SNMPv3
178
Modifying the Write View Name
To modify the Write View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Access Table.
The Configure SNMPv3 Access Table menu is displayed, as shown in
Figure 68 on page 170.
4. From the Configure SNMPv3 Access Table, select Modify SNMPv3
Table Entry.
The Modify SNMPv3 Table Entry menu is displayed, as shown in
Figure 69 on page 176.
5. To modify the Write View Name parameter, select Set Write View
Name.
The following prompt is displayed:
Enter Group Name:
6. Enter a Group Name that was previously configured.
The following prompt is displayed:
Enter Security Model[1-v1, 2-v2c, 3-v3]:
7. Enter the Security Model configured for this Group Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols:
1-v1
Select this value to associate the Group Name with the SNMPv1
protocol.
2-v2c
Select this value to associate the Group Name with the SNMPv2c
protocol.