Allied Telesis AT-S70 - Manual (Page 205)

AT-S70 Management Software User’s Guide
205
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the Configure SNMPv3 User Table menu, select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is displayed, as
shown in Figure 77.
Figure 77. Configure SNMPv3 Target Address Table Menu
4. To create an entry in the SNMPv3 Target Address Table, select
Create SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Address Name:
5. Enter the name of the SNMP manager, or host, that manages the
SNMP activity on your switch.
You can enter a name of up to 32 alphanumeric characters.
The following prompt is displayed:
Enter IP Address:
6. Enter the IP address of the host.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
The following prompt is displayed:
Enter UDP Port#: [0 to 65535]-> 162
7. Enter a UDP port.
You can enter a UDP port in the range of 0 to 65,535. The default UDP
port is 162.
Configure SNMPv3 Target Address Table
Converteon
Create SNMPv3 Table Entry
Delete SNMPv3 Table Entry
Modify SNMPv3 Table Entry
Display SNMPv3 Table Entry
Return to SNMPv3 Configurations ...