Allied Telesis AT-S70 User Manual
Page 31
AT-S70 Management Software User’s Guide
31
chassis loses the values when it is reset or power cycled. Therefore, you
must reset the values whenever you reset the chassis.
To set the system’s date and time, perform the following procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 3 on
page 29.
2. Adjust the following parameters as necessary:
System Date(mm/dd/yy)
Enter a date for the system in the “mm/dd/yy” format. Use two numbers
to specify for the day, month, and year. Separate the values with
slashes.
Select the System Time(hh:mm:ss)
Enter the new system real time in the “hh:mm:ss” format. Use two
numbers to specify for the hours, minutes, and seconds. Separate the
values with colons.
Note
When the AT-CV5M01 Management Card is reset or power cycled,
the date and time settings are lost and must be re-entered.
3. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 3 on
page 29.
4. From the System Configuration Menu, select Save Configuration
File.
Configuring the
System Location
and Contact
Information
To set the system’s location and contact information, perform the following
procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 3 on
page 29.
2. From the System Configuration Menu, select IP Parameters.