Allied Telesis AT-S70 - Manual (Page 201)

AT-S70 Management Software User’s Guide
201
I-Inform
Indicates this notify table is used to send inform messages. With this
message type, the switch expects a response from the host.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying a Storage Type
To modify the Storage Type parameter in an SNMPv3 Notify Table entry,
perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Notify Table.
The Configure SNMPv3 Notify Table menu is displayed, as shown in
Figure 74 on page 196.
4. From the Configure SNMPv3 Notify Table menu, select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Notify Table menu is displayed, as shown in
Figure 75 on page 199.
5. To modify the Storage Type, select Set Storage Type.
The following prompt is displayed:
Enter Notify Name:
6. Enter a Notify Name.
The following prompt is displayed:
Enter Storage type [V-Volatile, N-NonVolatile]:
7. Select one of the following storage types for this table entry: