Allied Telesis AT-S70 - Manual (Page 149)

AT-S70 Management Software User’s Guide
149
Note
You can only configure the Privacy Protocol if you have configured
the Authentication Protocol with the MD5 or SHA values.
8. Select one of the following options:
D-DES
Select this value to make the DES privacy (or encryption) protocol the
privacy protocol for this User Table entry. With this selection,
messages transmitted between the host and the switch are encrypted
with the DES protocol.
N-None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between the
host and the switch are not encrypted.
If you select NONE, you are prompted for the Storage Type. Proceed
to step 9.
If you select DES, the following prompt is displayed:
Enter Privacy Password:
9. Enter a privacy password (with a minimum of 8 and a maximum of 32
alphanumeric characters) and press Return.
You are prompted to re-enter the password.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
10. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 User Table to nonvolatile memory.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 User Table to nonvolatile memory. Allied Telesis
recommends this storage type.
The following prompt is displayed:
Do you want to create this table entry? (Yes or No):
11. Type Y to create a new table entry, or type N to cancel the entry.