Allied Telesis AT-S70 - Manual (Page 180)

Chapter 9: SNMPv3
180
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
11. From the System Configuration Menu, select Save Configuration
File.
Modifying the Notify View Name
To modify the Notify View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Access Table.
The Configure SNMPv3 Access Table menu is displayed, as shown in
Figure 68 on page 170.
4. From the Configure SNMPv3 Access Table, select Modify SNMPv3
Table Entry.
The Modify SNMPv3 Table Entry menu is displayed, as shown in
Figure 69 on page 176.
5. To modify the Notify View Name parameter, select Set Notify View
Name.
The following prompt is displayed:
Enter Group Name:
6. Enter a Group Name that was previously configured.
The following prompt is displayed:
Enter Security Model[1-v1, 2-v2c, 3-v3]:
7. Enter the Security Model configured for this Group Name. You cannot
change the value of the Security Model parameter.
Select one of the following SNMP protocols: