Allied Telesis AT-S70 - Manual (Page 209)

AT-S70 Management Software User’s Guide
209
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the Configure SNMPv3 User Table menu, select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is displayed, as
shown in Figure 77 on page 205.
4. From the Configure SNMPv3 Target Address Table menu, select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is displayed, as
shown in Figure 78.
Figure 78. Modify SNMPv3 Target Address Table Menu
5. To change the Target IP Address, select Set Target IP Address.
The following prompt is displayed:
Enter Target Address Name:
6. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32
alphanumeric characters.
Converteon
Configure SNMPv3 Target Address Table
Modify SNMPv3 Table Entry
Set Target IP Address
Set Target Address UDP Port
Set Target Address Timeout
Set Target Address Retries
Set Target Address Tag List
Set Target Parameters Field
Set Storage Type
Return to Configure SNMPv3 Target Address Table ...