Allied Telesis AT-S70 - Manual (Page 230)

Chapter 9: SNMPv3
230
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying the Message Process Model
You can modify the Message Process Model for SNMPv1 and SNMPv2c
protocol configurations only. When you configure the SNMPv3 protocol,
the Message Process Model is automatically assigned to the SNMPv3
protocol.
To modify the Message Process Model parameter in an SNMPv3 Target
Parameter Table entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Target Parameters Table.
The Configure SNMPv3 Target Parameters Table menu is displayed,
as shown in Figure 80 on page 220.
4. From the Configure SNMPv3 Target Parameters Table menu, select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table menu is displayed, as
shown in Figure 81 on page 226.
5. To modify the Message Process Model, select Set Message
Processing Model.
The following prompt is displayed:
Enter Target Parameters Name:
6. Enter a previously configured Target Parameters Name.
Enter a value of at least 8 alphanumeric characters with a maximum of
32 alphanumeric characters.
The following prompt is displayed: