Allied Telesis AT-S70 - Manual (Page 165)

AT-S70 Management Software User’s Guide
165
parameter is dependent on the subtree you select. For example, if you
configure the View Subtree parameter as MIB, ifEntry.0.3 has the
following value:
1.3.6.1.2.1.2.2.1.0.3
To restrict the user’s view to the third row (all columns) of the ifEntry
MIB, enter the following value for the Subtree Mask parameter:
ff:bf
9. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
10. From the System Configuration Menu, select Save Configuration
File.
Modifying a View Type
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
View Table.
The Configure SNMPv3 View Table menu is displayed, as shown in
Figure 65 on page 160.
4. From the Configure SNMPv3 View Table menu, select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Table Entry menu is displayed, as shown in
Figure 66 on page 164.
5. To modify the View Type, select Set View Type.
The following prompt is displayed:
Enter View Name:
6. Enter a View Name that was previously configured.
The following prompt is displayed: