Allied Telesis AT-S70 User Manual
Page 24
Chapter 2: Starting a Local or Remote Management Session
24
Note
The Converteon™ chassis has an auto-detect feature on the serial
port that automatically determines the speed of the local terminal.
You activate this feature by pressing the Return or Enter key twice
on your keyboard when you initially start the local interface or within
five seconds after powering on or resetting the chassis. The chassis
determines the speed of the terminal and automatically configures
the speed of the “console” port accordingly. If no key is pressed, the
chassis uses the default rate of 115200 bits per second (bps). The
chassis maintains the terminal port speed until the system is again
powered ON or reset.
Note
The default settings for the terminal interface are for a DEC VT100
or ANSI terminal, or an equivalent terminal emulator program.
The software initializes and then the login prompt is displayed.
4. Press
5. When prompted, enter a username and password.
To configure the chassis settings, enter “manager” as the
username. The default password for manager access is “friend”.
To only view the settings, enter “operator” as the username. The
default password for operator access is “operator”.
Usernames and passwords are case-sensitive.
For information on these two access levels, refer to “Configuring
Management Access” on page 50.
For instructions on how to change a password, refer to “Configuring
the Manager and Operator Passwords” on page 46.