Allied Telesis AT-S70 - Manual (Page 155)

AT-S70 Management Software User’s Guide
155
Modifying the Privacy Protocol and Password
To modify the Privacy Protocol and Password in an SNMPv3 User Table
entry, perform the following procedure.
Note
You can only configure the Privacy Protocol if you have configured
the Authentication Protocol with the MD5 or SHA values.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
User Table.
The Configure SNMPv3 User Table menu is displayed, as shown in
Figure 62 on page 147.
4. From the Configure SNMPv3 User Table menu, select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 User Table is displayed, as shown in Figure 63
on page 152.
5. To change the privacy protocol and password, select Set Privacy
Protocol and Password.
The following prompt is displayed:
Enter User (Security) Name:
6. Enter the User Name.
The following prompt is displayed:
Enter Privacy Protocol [D-DES, N-None]:
7. Choose one of the following Privacy Protocols:
D -DES
Select this value to make the DES privacy (or encryption) protocol the
privacy protocol for this User Table entry. With this selection,