Allied Telesis AT-S70 - Manual (Page 182)

Chapter 9: SNMPv3
182
A Notify View Name permits the users assigned to this Security Group
to send traps specified in this view of the MIB tree. This value does not
need to be unique.
10. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
11. From the System Configuration Menu, select Save Configuration
File.
Modifying the Storage Type
To modify the Storage Type parameter in an SNMPv3 Access Table entry,
perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Access Table.
The Configure SNMPv3 Access Table menu is displayed, as shown in
Figure 68 on page 170.
4. From the Configure SNMPv3 Access Table, select Modify SNMPv3
Table Entry.
The Modify SNMPv3 Table Entry menu is displayed, as shown in
Figure 69 on page 176.
5. To modify the Storage Type parameter, select Set Storage Type.
The following prompt is displayed:
Enter Group Name:
6. Enter a Group Name that was previously configured.
The following prompt is displayed:
Enter Security Model[1-v1, 2-v2c, 3-v3]: