Allied Telesis AT-S70 - Manual (Page 163)

AT-S70 Management Software User’s Guide
163
The following prompt is displayed:
Do you want to Delete this table entry? (Yes or No):
7. Enter Y to delete the selected table entry or N to save the entry.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying an
SNMPv3 View
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. Refer to the following procedures:
ˆ “Modifying a Subtree Mask” on page 163
ˆ “Modifying a View Type” on page 165
ˆ “Modifying a Storage Type” on page 166
Modifying a Subtree Mask
To modify the Subtree Mask parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
View Table.
The Configure SNMPv3 View Table menu is displayed, as shown in
Figure 65 on page 160.
4. From the Configure SNMPv3 View Table menu, select Modify
SNMPv3 Table Entry.