Allied Telesis AT-S70 - Manual (Page 197)

AT-S70 Management Software User’s Guide
197
8. Select one of the following storage types for this table entry:
V-Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 Notify Table to the configuration file.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Notify Table to the configuration file. Allied Telesis
recommends this storage type.
The following prompt is displayed:
Do you want to create this table entry? (Yes or No):
9. Type Y to create a new table entry, or type N to cancel the entry.
10. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
11. From the System Configuration Menu, select Save Configuration
File.
Deleting an
SNMPv3 Notify
Table Entry
You may want to delete an entry from the Configure SNMPv3 Notify Table
menu. When you delete a Configure SNMPv3 Notify Table entry, there is
no way to undelete, or recover, the entry.
To delete an entry in the Configure SNMPv3 Notify Table menu, perform
the following procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Notify Table.
The Configure SNMPv3 Notify Table menu is displayed, as shown in
Figure 74 on page 196.