Allied Telesis AT-S70 - Manual (Page 200)

Chapter 9: SNMPv3
200
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying a Notify Type
To modify the Notify Type parameter in an SNMPv3 Notify Table entry,
perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Notify Table.
The Configure SNMPv3 Notify Table menu is displayed, as shown in
Figure 74 on page 196.
4. From the Configure SNMPv3 Notify Table menu, select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Notify Table menu is displayed, as shown in
Figure 75 on page 199.
5. To modify the Notify Type, select Set Notify Type.
The following prompt is displayed:
Enter Notify Name:
6. Enter a Notify Name.
The following prompt is displayed:
Enter Notify Type [T-Trap, I-Inform]:
7. Enter one of the following message types:
T-Trap
Indicates this notify table is used to send traps. With this message
type, the switch does not expect a response from the host.