Allied Telesis AT-S70 - Manual (Page 129)

AT-S70 Management Software User’s Guide
129
OAM Loopback Test
This section contains the following procedures for managing the OAM
loopback test:
ˆ “Enabling or Disabling a Remote Loopback Test,” next
ˆ “Starting or Stopping a Loopback Test” on page 130
ˆ “Displaying or Clearing the Loopback Test Statistics” on page 131
Enabling or
Disabling a
Remote
Loopback Test
To enable or disable the OAM remote loopback test, perform the following
procedure:
1. From the Main Menu, select Remote Module Status and
Configuration.
The Remote Module Status and Configuration Menu is displayed, as
shown in Figure 15 on page 59.
2. Select the line card whose loopback test you want to configure.
3. Press .
The Module Configuration Menu is displayed, as shown in Figure 47
on page 116.
4. Select the port whose loopback test you want to configure.
5. Press .
The Port Management Menu is displayed, as shown in Figure 48 on
page 116.
6. From the Port Management Menu, select OAM Configurations.
The OAM Configuration Menu is displayed, as shown in Figure 49 on
page 117.
7. From the OAM Configuration Menu, select OAM Loopback Test.