Allied Telesis AT-S70 - Manual (Page 215)

AT-S70 Management Software User’s Guide
215
Table entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the Configure SNMPv3 User Table menu, select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is displayed, as
shown in Figure 77 on page 205.
4. From the Configure SNMPv3 Target Address Table menu, select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is displayed, as
shown in Figure 78 on page 209.
5. To modify the Target Parameters field, select Set Target Parameters.
The following prompt is displayed:
Enter Target Address Name:
6. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32
alphanumeric characters.
The following prompt is displayed:
Enter Target Parameters:
7. Enter a Target Parameters Name.
The value configured here must match the value configured with the
Target Parameters Name parameter in the Configure SNMPv3 Target
Parameters Table. This name can consist of up to 32 alphanumeric
characters.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.