Allied Telesis AT-S70 - Manual (Page 36)

Chapter 3: Basic Parameters
36
Configuring
SNMP
Community
Strings
To configure the SNMP community strings, perform the following
procedure:
Note
SNMP access is disabled by default. To enable SNMP access, refer
to “Configuring Management Access” on page 50.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 3 on
page 29.
2. From the System Configuration Menu, select IP Parameters.
The IP Parameters Menu is displayed, as shown in Figure 4 on page
32.
3. Adjust the community strings as necessary. A community string can be
up to thirteen characters. Community strings are case sensitive and
can contain spaces and special characters, such as an exclamation
point (!). Changes to the SNMP parameters are immediately activated
on the chassis.
Get community string
The default setting for this string is “public.”
Set community string
The default setting for this string is “private.”
Trap community string
The default setting for this string is “public.”
4. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 3 on
page 29.
5. From the System Configuration Menu, select Save Configuration
File.