Allied Telesis AT-S70 - Manual (Page 220)

Chapter 9: SNMPv3
220
There are three functions you can perform with the Configure SNMPv3
Target Parameters Table menu.
ˆ “Creating an SNMPv3 Target Parameters Table Entry,” next
ˆ “Deleting an SNMPv3 Target Parameters Table Entry” on page 223
ˆ “Modifying an SNMPv3 Target Parameters Table Entry” on page 224
ˆ “Displaying the SNMPv3 Target Parameters Table Menu” on page 232
Creating an
SNMPv3 Target
Parameters Table
Entry
To create an entry in the Configure SNMPv3 Target Parameters Table,
perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Target Parameters Table.
The Configure SNMPv3 Target Parameters Table menu is displayed,
as shown in Figure 80.
Figure 80. Configure SNMPv3 Target Parameters Table Menu
4. To create an SNMPv3 Target Parameters Table, select Create
SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a name of the Target Parameters.
Configure SNMPv3 Target Parameters Table
Converteon
Create SNMPv3 Table Entry
Delete SNMPv3 Table Entry
Modify SNMPv3 Table Entry
Display SNMPv3 Table Entry
Return to SNMPv3 Configurations ...