Allied Telesis AT-S70 - Manual (Page 266)

Appendix B: DIP Switch Settings
266
AT-CV10x Series Line Cards DIP Switches
The AT-CV10x series line cards feature two sets of DIP switches labeled
“SW1” and “SW 2” as shown in Figure 90.
Figure 88. DIP Switch Sets on an AT-CV10x Series Line Card
The DIP switches in the SW 1 DIP switch set allow you to set the
operating mode of the line card. For information about the operating
modes, refer to “Configuring the Line Card Operating Mode” on page 67.
The DIP switches in the SW 2 DIP switch set allow you to configure the
MDI/MDI-X feature on the twisted pair port.
Table 4 shows how to enable the operating mode on an AT-CV10x Series
line card by setting the DIP switches in the SW 1 DIP switch set.
“X” means that the DIP switch position can be ON or OFF.
1 2
3 4
1 2
3 4
AT-CM20
2
LK AT
T
X
M
1 2
3 4
1 2
3 4
SW1
SW2
ON
ON
SW 2 DIP Switch Set
SW 1 DIP Switch Set
Table 4. SW 1 DIP Switch Set (Operating Mode) for the AT-CV10x Series
Line Cards
Operating Mode DIP 1 DIP 2 DIP 3 DIP 4
Link Test (default) OFF OFF X X
Smart MissingLink (SML) OFF ON X X
MissingLink™ (ML) ON OFF X X
Manufacturing Default Settings OFF OFF OFF OFF