Allied Telesis AT-S70 - Manual (Page 61)

AT-S70 Management Software User’s Guide
61
Configuring Generic Line Card Settings
You can change the following settings to fit your network needs:
ˆ “Enabling and Disabling the Ports on a Line Card,” next
ˆ “Changing the Line Card Port Duplex Mode” on page 62
ˆ “Configuring the Port Ingress/Egress Rate Limit” on page 63
Enabling and
Disabling the
Ports on a Line
Card
When you enable the ports on a line card, you make it available to send
and receive network traffic.
Note
Enabling and disabling ports only affects the ability of the port to
pass traffic. IT does not physically enable or disable the physical
link.
To verify if the port on a line card is enabled or disabled, or to change that
setting, perform the following procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu is displayed, as shown in
Figure 12 on page 53.
2. Select the line card.
3. Press .
The Module Configuration Menu is displayed, as shown in Figure 13
on page 55.
4. Select the port to be enabled or disabled.
5. Press .
The Port Management Menu is displayed, as shown in Figure 17.
Figure 17. Port Management Menu
Port Management Menu
Module 4 - Port A
Port Configurations
OAM Configurations
Return to Module Configuration Menu...