Allied Telesis AT-S70 - Manual (Page 175)

AT-S70 Management Software User’s Guide
175
Modifying an
SNMPv3 Access
Table Entry
This section describes how to modify parameters in an SNMPv3 Access
Table entry. For each entry in the SNMPv3 Access Table, you can modify
the following parameters:
ˆ Read View Name
ˆ Write View Name
ˆ Notify View Name
ˆ Storage Type
Configure the values of the Read View Name, Write View Name, and
Notify View Name parameters with values previously configured with the
View Name parameter in the SNMPv3 View Table. This is the only way to
associate a Group Name with these Views. Refer to “Creating an SNMPv3
View Table Entry” on page 159.
Refer to the following procedures:
ˆ “Modifying the Read View Name” on page 175
ˆ “Modifying the Write View Name” on page 178
ˆ “Modifying the Notify View Name” on page 180
ˆ “Modifying the Storage Type” on page 182
Modifying the Read View Name
To modify the Read View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Access Table.
The Configure SNMPv3 Access Table menu is displayed, as shown in
Figure 68 on page 170.
4. From the Configure SNMPv3 Access Table, select Modify SNMPv3
Table Entry.