Allied Telesis AT-S70 - Manual (Page 214)

Chapter 9: SNMPv3
214
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the Configure SNMPv3 User Table menu, select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is displayed, as
shown in Figure 77 on page 205.
4. From the Configure SNMPv3 Target Address Table menu, select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is displayed, as
shown in Figure 78 on page 209.
5. To modify the Target Address Tag List, select Set Target Address
TagList.
The following prompt is displayed:
Enter Target Address Name:
6. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32
alphanumeric characters.
The following prompt is displayed:
Enter Tag List:
Enter a Tag List of up to 256 alphanumeric characters. Use a space to
separate entries. This list consists of a tag or list of tags you configured
in a Configure SNMPv3 Notify Table entry with the Notify Tag
parameter. Refer to “Creating an SNMPv3 Notify Table Entry” on
page 195.
7. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
8. From the System Configuration Menu, select Save Configuration
File.
Modifying the Target Parameters Field
To modify the Target Parameters field in an SNMPv3 Target Address