Allied Telesis AT-S70 - Manual (Page 231)

AT-S70 Management Software User’s Guide
231
Enter Message Processing Model[1-v1,2-v2c,3-v3]:
7. Select one of the following SNMP protocols that is used to process, or
send messages:
1-v1
Select this value to process messages with the SNMPv1 protocol.
2-v2c
Select this value to process messages with the Security Name, or User
Name, with the SNMPv2c protocol.
3-v3
Select this value to process messages with the SNMPv3 protocol.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying the Storage Type
To modify the Storage Type parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Target Parameters Table.
The Configure SNMPv3 Target Parameters Table menu is displayed,
as shown in Figure 80 on page 220.
4. From the Configure SNMPv3 Target Parameters Table menu, select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table menu is displayed, as
shown in Figure 81 on page 226.
5. To modify the Storage Type, select Storage Type.