Allied Telesis AT-S70 - Manual (Page 190)

Chapter 9: SNMPv3
190
7. Enter Y to delete this SNMPv3 Group table entry or N to save the
Group table entry.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Modifying an
SNMPv3 Group
Table Entry
This section describes how to modify parameters in an SNMPv3 Group
Table entry. Refer to the following procedures:
ˆ “Modifying the Group Name” on page 190
ˆ “Modifying the Storage Type” on page 192
Modifying the Group Name
To modify the Group Name in an SNMPv3 Group Table entry, perform the
following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Group Table.
The Configure SNMPv3 Group Table menu is displayed, as shown in
Figure 71 on page 187.
4. From the Configure SNMPv3 Group Table, select Modify SNMPv3
Table Entry.