Avaya 580 - Manual (Page 739)

Document No. 10-300077, Issue 2 B-3
Boot Mode
Downloading New Operational Code
To download new operational code in BOOT mode into APP1 or APP2.
* Note: The Avaya P580 and P882 Multiservice switches do not have an
IP address assigned to the console ethernet port when it comes
up in BOOT mode. Therefore, a user must assign an IP address
(and default gateway) to the ethernet console port prior to
attempting the TFTP download of a new operational image.
1. Ensure the ethernet console port is connected to the network for a TFTP
transfer.
2. Enter the following command to assign an IP address to the ethernet
console port:
Boot> ip address
3. Enter the following command to assign a default gateway to the ethernet
console port (if necessary):
Boot> ip default_gateway
4. Enter the following command to download new operational code to
APP1 or APP2:
Boot> download {app1 | app2}
5. Enter the following command to set the switch to boot from the
appropriate image stored in APP1 or APP2
Boot> feprom set {app1 | app2}
6. Enter the following command to reset the switch:
Boot> reset