Avaya 580 - Manual (Page 541)

Document No. 10-300077, Issue 2 18-11
Configuring the IPX SAP Protocol
Filter 2
Filter 2 ensures that all networks and service types are filtered for the
indicated interface.
1. In the navigation pane, expand the Routing > IPX > SAP folders, and
then click Net Filters.
The IPX SAP Net Filters Web page is displayed in the content pane. See
Figure 18-4 .
2. Click CREATE to create a new filter. The Add IPX SAP Net Filter Web
page is displayed. See Figure 18-5 .
3. Configure the following parameters:
a. Select an interface name from the Interface pull-down menu.
b. Enter 1 in the Precedence field.
c. Enter ffffffff (which represents all networks) in the Net field.
d. Enter ffff (which represents all services/types) in the Type field.
e. Select Inbound from the Direction pull-down menu.
f. Select Enable from the Filter/Suppress pull-down menu.
g. Enter 0 in the Hops field. Entering 0 ensures that there is no
override in the transmission of data on the network.
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Command To create IPX SAP Network filters using the CLI, enter the following
command from Interface mode:
(config if-)# ipx sap-network-filter
{outbound | inbound |
both} {filter | allow} []