Cli command, Table 12-17 – Avaya 580 User Manual
Page 384
12-56
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 12
CLI Command
To display the multicast group table using the CLI, enter the following
command from configuration mode:
(configure)#
show ip igmp groups
Displaying the IGMP Local Multicast Forwarding Cache
To display the multicast forwarding cache information (IGMP only
interfaces):
1. In the navigation pane, expand the Routing > IGMP folders, and then
click Local Multicast Forwarding Cache.
The Local Multicast Forwarding Cache Web page is displayed in the
content pane. See
Figure 12-27. Local Multicast Forwarding Cache Web Page
Table 12-17. IGMP Group Membership Table Web Page Fields
Parameter
Defines the...
Group Member Interface
Interface that is connected to a member of an
IGMP group.
Group Address
Group address that has members on this interface.
Group Created On
Time at which the group was created on the router.
Group Multicast Protocol
Routing protocol being used for the group. If no
routing protocol is being used on the interface a
group is on, this column displays IGMP.
Group Reporter Address
IP address of the host that sent the most recent host
membership report for this group.
Entry Expiration Period in
(sec)
Expiration time (in seconds) of the group that is
being displayed.