Cli command, Creating ospf areas, Web agent procedure – Avaya 580 User Manual
Page 467: Creating ospf areas -5
Document No. 10-300077, Issue 2
15-5
Configuring the OSPF Routing Protocol
CLI Command
To globally configure OSPF, use the following command:
(configure)#
router ospf
Creating OSPF Areas
You can create OSPF areas using either the Web Agent or the CLI.
Web Agent
Procedure
To create OSPF areas using the Web Agent:
1. In the navigation pane, expand the Routing > IP > OSPF folders, and
then click Areas.
The OSPF Areas Web page is displayed in the content frame. See
.
* Note: The Area ID 0.0.0.0 is a backbone area and always exists in an
OSPF configuration.
Figure 15-2. OSPF Areas Web Page
2. Click CREATE. The Add OSPF Area Web page is displayed. See
.
Static Ext Type
Specify whether imported high preference static routes are
advertised in OSPF with type 1 (internal) or type 2
(external) metrics.
Static Low Ext
Type
Specify whether imported low preference static routes are
advertised in OSPF with type 1 (internal) or type 2
(external) metrics.
Table 15-1. OSPF Global Configuration Web Page Parameters
Parameter
Explanation
2 of 2