Cli command, Creating ipx static routes, Web agent procedure – Avaya 580 User Manual
Page 503: Creating ipx static routes -9
Document No. 10-300077, Issue 2
16-9
Configuring IPX Routing
CLI Command
To begin the creation of a new IPX interface using the CLI, enter the
following command in Configure mode:
(configure)#
interface
Creating IPX Static Routes
You can create IPX static routes using either the Web Agent or the CLI.
Web Agent
Procedure
To create IPX static routes using the Web Agent:
1. In the navigation pane, expand the Routing > IPX > Configuration
folders, and then click Static Routes.
The IPX Static Routes Web page is displayed in the content pane. See
.
Figure 16-6. IPX Static Routes Web Page
SAP
Select Disable to prevent IPX SAP from routing
globally. This affects all IPX interfaces set up to use the
IPX SAP routing protocol. The default value is Enable.
Type 20 Packet
Propagation
Specify whether or not Type 20 packets can be sent,
received, disabled, or sent and received on a given
interface.
Options include:
Disable - Type 20 packets are neither sent nor received.
Inbound - Type 20 packets are received.
Outbound - Type 20 packets are sent.
Both - Type 20 packets are sent and received.
The default value is Disable
Table 16-3. IPX Interface Web Page Parameters
Parameter
Allows you to...
2 of 2