Avaya 580 - Manual (Page 561)

Document No. 10-300077, Issue 2 19-17
Configuring AppleTalk Routing
3. Click:
— CREATE to add a new filter. The Add AppleTalk NBP Filter
Web page is displayed. See “
Creating an AppleTalk Name-
Binding Protocol (NBP) Filter ” earlier in this chapter for more
information.
— DELETE to remove the selected NBP filter.
— CANCEL to restore previous settings.
— Edit If to add or delete this NBP filter to/from an interface. The
Add/Delete Interface to NBP Filter Web page is displayed. See
“
Adding or Deleting Interfaces to an NBP Filter ” later in this
chapter for more information.
CLI Command To edit an AppleTalk NBP filter using the CLI, enter the following
command in Interface mode:
(config-if:)# appletalk access-list
list-number> {permit | deny} nbp
Adding or Deleting Interfaces to an NBP Filter
You can add or delete interfaces to an NBP filter using either the Web Agent
or the CLI.
Web Agent
Procedure To add or delete interfaces to an NBP filter using the Web Agent:
1. In the navigation pane, expand the Routing > AppleTalk >
Configuration folders, and then click NBP Filter.
The AppleTalk NBP Filter Web page is displayed in the content pane.
See
Figure 19-14 .
2. Select Edit If. The Add/Delete Interface to NBP Filter Web page is
displayed. See Figure 19-15 .