Avaya 580 - Manual (Page 165)

Document No. 10-300077, Issue 2 5-23
Configuring SNMP
Disabling or Reenabling SNMP
Disabling SNMP To disable SNMP, use the following CLI command:
(configure)# no snmp-server
This command overrides secure mode, which disables SNMPv1 and v2 and
enables SNMPv3. For information on secure mode, see “
Secure Mode .”
Reenabling SNMP To reenable SNMP, use the following CLI command:
(configure)# snmp-server enable
This command enables the three versions of SNMP: SNMPv1, v2, and v3.
Viewing the SNMP Status
To view the status of SNMP, use the following CLI command:
(configure)# show snmp
This command displays the status of SNMP (enabled or disabled) and the
administrative contact and physical location of the switch, if set.