Cli commands, Setting up nbma neighbors, Web agent procedure – Avaya 580 User Manual
Page 492: Setting up nbma neighbors -30
15-30
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 15
7. Click APPLY to save your changes, or CANCEL to restore previous
settings.
*Note: You must bring the IP interface Down to successfully
enable OSPF on the IP interface. If you do not, you will
get an error message and OSPF will not be enabled.
CLI Commands
To use the CLI to set up an NBMA IP interface:
1. Enter Configuration mode. The CLI displays the following prompt:
(configure)#
2. Enter the following command at the prompt:
(configure)#
interface
The following prompt displays:
(configure-if:
3. Enter the following command at the prompt:
ip address
4. Enter the following command at the prompt:
type nbma
Setting Up NBMA Neighbors
Web Agent
Procedure
To use the Web Agent to set up NBMA neighbors:
1. Open the Routing > IP > RIP or OSPF folders, whichever one was
created with an NBMA type interface.
2. Click NBMA Neighbors. The RIP or OSPF NBMA Neighbors Web
page is displayed.
3. Click Create. The Add NBMA RIP or OSPF Neighbor Web page is
displayed.
4. Enter a neighbor IP interface address in the Network Address field.
5. Click CREATE, or CANCEL to restore previous setting.