beautypg.com

Avaya 580 User Manual

Page 271

background image

Document No. 10-300077, Issue 2

8-49

Configuring Ports

See

Table 8-11

for explanations of the keywords, arguments, and

options in this command.

The CLI displays a confirmation message if you successfully enable
NEDR for a port or range of ports. If no message displays, the port
information was invalid.

* Note: Occasionally, if you enable NEDR on a 10-Gigabit port, the

following error message is displayed:

Set port network-error-detection failed:

<10-Gigabit port number>

.

NEDR is successfully enabled regardless of the error message.
Ignore the error message.

3. To verify that NEDR is enabled on a port, enter the following CLI

command:

show port network-error-detection []

If the port is not listed as enabled for NEDR, reenable NEDR on the
same port or ports again.

Table 8-11. Keywords, Arguments, and Options

Keywords, Arguments
and Options

Explanation

The slot number of the module, and, either port
number, or range of port numbers. Enter the port
ranges in the format

Px

-

Py

. For example:

• To specify port 1 on the module in slot 3,

enter 3/1.

• To specify ports 1 through 5 on the module

in slot 3, enter 3/1-5.

all

Disables NEDR on all ports on all modules in the
switch. all can be used only with off.

Note:

The set port network-error-detection

all action off CLI command does not
turn off NEDR on 10-Gigabit ports. To
turn off network error detection for
specific 10-Gigabit ports, use the set
port network-error-detection

port-range>

action off command.

1 of 2

This manual is related to the following products: