Avaya 580 - Manual (Page 587)

Document No. 10-300077, Issue 2 20-9
Managing Intelligent Multicasting
CLI Command To display router ports using the CLI, enter the following command from
User mode:
> show intelligent-multicast router-port
Configuring Static Router Ports
You can configure Static Router ports using either the Web Agent or the
CLI.
Web Agent
Procedure To configure a static router port using the Web Agent:
1. In the navigation pane, expand the L2 Switching > Intelligent
Multicast folders, and then click Global Configuration.
The Intelligent Multicast Global Configuration Web page is displayed
in the content pane. See
Figure 20-2 .
*Note: You must enable intelligent multicasting on a global basis
to make your static router port configuration active. See
“
Configuring Global Intelligent Multicasting ” earlier in
this chapter.
2. Select Display/Configure Router Ports. The Router Port Display/
Configuration Web page is displayed. See Figure 20-3 .
3. Enter a port number in the Port field.
Table 20-2. Router Port Display/Configuration Web Page Parameters
Parameter Definition
Port Displays the switch port configured as a router port.
VLAN Displays which VLAN the router port is bound to.
Application Displays the active applications of the router port. The
applications include:
• Mgmt (Static)
• IGMP
• LGMP
• CGMP