Avaya 580 - Manual (Page 426)

13-6 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 13
Creating Access Rules
This section contains the following procedures:
■
Creating Standard Access Rules
■
Creating Extended Access Rules
Creating Standard Access Rules
To create standard access rules:
1. In the navigation pane, expand the Routing > IP > Configuration
folders, and then click Access Lists.
The IP Access List Web page is displayed in the content pane. See
Figure 13-1 .
*Note: The IP Access List displays all standard and extended
access rules that have been created. If no rules have been
created, the following statement displays:
No IP
Access Rules are currently configured .
Due to its size, Figure 13-1 shows the Access List Web
page split in two separate sections.
The switch supports a maximum total of 512 access
control rules, regardless of the number of access lists. For
example, you could create the following three ACLs:
• ACL A with 100 rules
• ACL B with 200 rules
• ACL C with 212 rules
The combined total of rules cannot exceed 512. Only one
access control list can be enabled at a time.
Index numbers of access rules can range from 1 to 512. Do
not use index numbers higher than 512.