Figure 18-1 – Avaya 580 User Manual
Page 532
18-2
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 18
Figure 18-1. IPX SAP Interfaces Web Page
2. See
to configure the IPX SAP Interface Web page
parameters.
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
Table 18-1. IPX SAP Interface Web Page Parameters
Parameter
Allows you to...
Select
Select a SAP interface to modify.
Interface
Identifies the IPX interface associated with the SAP
interface.
Network Number
Identifies the number of the IPX network associated
with the interface.
Use Interpacket Gap
Select one of the following from the pull-down menu:
• Disable – if you do not want the IPX SAP
periodic update packets to be sent out over an
interface with no interpacket transmission delay.
• Enable – If you want to send the IPX SAP
periodic update packets to be sent out over an
interface with an interpacket transmission delay
(default).
Use Max Packet Size
Select one of the following from the pull-down menu:
• Disable – To limit SAP packets to 7 service
entries(default).
• Enable – To allow SAP) packets to contain the
maximum number of services entries that are
allowed by the SAP Interface MTU (default).
Periodic Update
Interval (sec)
Enter (in seconds) the interval at which periodic SAP
updates are sent out an interface. Default is 60 seconds.
1 of 2