Avaya 580 - Manual (Page 736)

Appendix A
A-10 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
CLI Command To reset the switch after downloading new application software, use the
following CLI command:
(configure)# reset
Verifying the Upgrade
To verify that the old Active supervisor is now the Standby supervisor, the
LED display window (marquee) should scroll
Standby and the software
version.
Upgrading a Switch with Multiple VLANs
Statically Bound to Hunt Group Ports
If the switch has multiple VLANs statically bound to hunt group ports and
you want to upgrade from application software earlier than v5.3, you must:
1. Download the application software to which you want to upgrade.
2. Reset the switch to load this software.
3. Delete all hunt groups to which you want to statically bind multiple
VLANs.
4. Use the set vlan { | name }
range> [...,] CLI command to statically bind the
VLANs to every port that you want to assign to a hunt group.
5. Assign the ports to hunt groups.
6. Save the running configuration to the startup configuration.